Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
3-27
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 3 Installing the 8106 Server
Installing and connecting the modem
Step 6
Plug the IP LAN cable into the customer-supplied RJ-48c socket.
Step 7
Plug the other end of the IP LAN cable into the Ethernet 1 connector on the Multi Access Blade
transition module.
transition module.
Step 8
Repeat steps 6 and 7 if you have two Multi Access Blades.
Installing and connecting the modem
This section describes how to install and connect the modem. Verify the following things are included
in the modem package:
in the modem package:
•
modem
•
modem cable
•
modem power cable
•
telephone extension cable
Installing the modem in T1 CAS and pure IP systems
Follow these instructions to install the modem in T1 CAS or pure IP systems. If you are installing a
modem in a T1 PRI system or an E1 system, see the
modem in a T1 PRI system or an E1 system, see the
Step 1
Place the modem on the back, right corner of the server, as you are looking at the front of the server. The
modem cable connections should face the back of the server as in
modem cable connections should face the back of the server as in
The modem should remain here permanently.
Figure 3-21 Modem Placement and Connections