Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
3-29
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 3 Installing the 8106 Server
Installing and connecting the modem
Installing the modem in T1 PRI and E1 systems
Follow these instructions to install the modem in T1 PRI and E1 systems:
Step 1
Verify the modem’s power switch is in the off position. The modem’s power switch is on the side of the
modem.
modem.
Step 2
Looking at the back of the modem, connect the modem power cable to the far left position on the back
of the modem.
of the modem.
Step 3
Connect the other end of the modem power cable into the power outlet.
Step 4
Looking at the back of the modem, connect the telephone extension cable to the far right position on the
back of the modem, labeled “Line”. There are two RJ-11 connectors on the modem. This cable should
be placed in the far right connector.
back of the modem, labeled “Line”. There are two RJ-11 connectors on the modem. This cable should
be placed in the far right connector.
Step 5
Looking at the back of the modem, connect the DB25 end (the larger connector) of the modem cable to
the back of the modem. See
the back of the modem. See
to see which end is the DB25 end.
Step 6
Connect the DB9 end (the smaller connector) of the modem cable to the COM 2 port on the CPU
transition module in the back of the server. See
transition module in the back of the server. See
to see which end is the DB9 end. See
Step 7
Connect the other end of the telephone extension cable to its source. The source should be a standard
analog phone line, not an extension for a digital phone.
analog phone line, not an extension for a digital phone.
Step 8
Turn the modem’s power switch to the on position.
Step 9
Looking at the back of the server, place the modem into the empty slot on the far left of the breakout
box. See
box. See
. The modem should remain here permanently.
Figure 3-24 Breakout Box, Back View