Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-40
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
External sync prior-
ity
ity
none.
The T1 span con-
nected to the T1
Smart Blade in
slot 1, line A gets
sync priority 1,
line B gets 2, etc.
nected to the T1
Smart Blade in
slot 1, line A gets
sync priority 1,
line B gets 2, etc.
Specifies the priority of the
spans that are set for external
timing. The system always
tries to synchronize from the
highest priority span. If the
synchronization span goes
down, the system automati-
cally switches synchroniza-
tion to the next highest span.
If a higher priority span
comes up, the system auto-
matically synchronizes off of
it.
spans that are set for external
timing. The system always
tries to synchronize from the
highest priority span. If the
synchronization span goes
down, the system automati-
cally switches synchroniza-
tion to the next highest span.
If a higher priority span
comes up, the system auto-
matically synchronizes off of
it.
•
1-255 (1 is the high-
est, 255 is the low-
est)
est, 255 is the low-
est)
•
never
Trunk [x]
Numbering is
done in order (1,
2, 3, etc.). For
example,
done in order (1,
2, 3, etc.). For
example,
Trunk [1]:port 0
Trunk [2]:port 1
Trunk [3]:port 2
Specifies which port in the
database is assigned to the
specific hardware trunk on the
card.
database is assigned to the
specific hardware trunk on the
card.
•
number
Remote loopback to
network
network
n
Specifies if the span should be
put into a loopback mode for
testing from the remote end.
put into a loopback mode for
testing from the remote end.
•
y = yes
•
n = no (normal
operation)
operation)
Internal data loop-
back
back
n
Specifies if the span should
loop back locally for running
diagnostics.
loop back locally for running
diagnostics.
•
y = yes
•
n = no (normal
operation)
operation)
Port group
3
Specifies the number of the port
group.
group.
•
0 (T1 CAS)
•
1 (IP)
•
2 (E1)
•
3 (T1 PRI)
Active?
y (if you use a
blade to configure
T1)
blade to configure
T1)
Specifies if the port group is
active.
active.
•
y = yes
•
n = no
Card type
T1
Specifies the type of card.
•
none
•
T1
•
analog
•
E1
•
IP
Table 4-7
Default T1 PRI Span Configuration (continued)
Parameter
Default
Explanation
Possible Values
X