Cisco Cisco TelePresence Management Suite (TMS) Version 15
Configuring the TelePresence Conductor
This section describes how to configure your TelePresence Conductor to work when conferences are going
to be scheduled by Cisco TMS. Perform these procedures in the order they are listed.
to be scheduled by Cisco TMS. Perform these procedures in the order they are listed.
section before following the instructions below.
Creating a conference bridge pool for scheduled conferences
The following steps demonstrate how to configure TelePresence Conductor with a conference bridge pool
that is dedicated for scheduled conferences only. This conference bridge pool must not be included in any
Service Preferences used by conference templates for non-scheduled conferences.
that is dedicated for scheduled conferences only. This conference bridge pool must not be included in any
Service Preferences used by conference templates for non-scheduled conferences.
1. Log into the TelePresence Conductor as a user with administrator rights.
2. Go to
Conference Configuration > Conference bridges > Conference bridge pools
.
3. Click New.
4. In the Pool name field enter a name, for example:Scheduled MCUs.
5. Click Create pool.
Adding a conference bridge to the conference bridge pool for
scheduled conferences
scheduled conferences
1. Click Add conference bridge.
2. Enter the following in the relevant fields:
Name
A name for your conference bridge, for example: MCU for scheduled conferences.
IP address
or FQDN
or FQDN
The IP address or FQDN of the conference bridge.
Protocol
The protocol the TelePresence Conductor will use to communicate with the conference
bridge.
bridge.
Enter: HTTPS
Port
The port number the TelePresence Conductor will use to communicate with the conference
bridge:
bridge:
Enter: 443
Conference
bridge
username
bridge
username
bridges.
Conference
bridge
Password
bridge
Password
The password for the username above.
Dial plan
prefix
prefix
The prefix that has been defined as part of a Cisco VCS search rule to route calls to this
MCU.
MCU.
Dedicated
content
ports
content
ports
Enter the number of dedicated content ports for your MCU. This is found on the MCU under
Settings > Media ports
.
Cisco TelePresence Conductor with Cisco TMS Deployment Guide
Page 7 of 21
Configuring the TelePresence Conductor