Cisco Cisco TelePresence Management Suite (TMS) Version 15 Installation Guide
2. Go to
Administrative Tools > Activity Status
to verify that the switch is completed.
3. Verify that Cisco TMSPE features are now available and functioning.
a. Browse to the following pages in Cisco TMS:
o
Systems > Provisioning > Users
. If this page reports a problem connecting to User Repository,
o
Systems > Provisioning > Devices
o
Systems > Provisioning > FindMe
Note that
Systems > Provisioning > FindMe
will be displayed with an error message if when/if
FindMe has been enabled.
o
Administrative Tools > Configuration > Provisioning Extension Settings
b. Go to
Administrative Tools > Provisioning Extension Diagnostics
, look for any alarms raised and
click Run Health Check. If any alarms are raised, click them to see details and perform the corrective
actions described. See
actions described. See
for further information.
4. When browsing to all of the above Cisco TMSPE pages is successful and no alarms are reported in
Provisioning Extension Diagnostics
Setting up communication between Cisco TMS and Cisco
VCS
VCS
Perform this procedure to enable the Cisco VCS or VCS clusters to communicate with Cisco TMSPE. If
Cisco VCSs are clustered, configure only one Cisco VCS in the cluster.
Cisco VCSs are clustered, configure only one Cisco VCS in the cluster.
n
Cisco VCS imports the user configurations, FindMe settings, phone books and licensing information from
Cisco TMSPE.
Cisco TMSPE.
n
Cisco TMSPE receives information about provisioned devices from Cisco VCS.
Follow these steps:
1. In Cisco TMS, go to
Systems > Navigator
and select the Cisco VCS. This can be any Cisco VCS from
the cluster.
2. Click the
Provisioning
tab.
3. At the bottom of the page, click the Set Default Connection Settings button.
The
Cisco TMS Connection Settings
pane is populated with suggested values.
Cisco TelePresence Management Suite Provisioning Extension with Cisco VCS Deployment Guide (1.3)
Page 28 of 93
Installing Cisco TMSPE