Cisco Cisco Unified IP Interactive Voice Response (IVR) 8.0(1) Quick Setup Guide
5-4
Getting Started with Cisco Unified IP IVR, Release 6.0(1)
Chapter 5 Installing and Configuring Unified CM for Unified IP IVR
Unified CM Configuration Check List
How to Check Your Phone Configuration in Unified CM or in Unified
CME
CME
1.
Using a Web browser, open Unified CM Administration. This URL is commonly:
https://<Communications Manager_servername>/ccmadmin
2.
From the Device menu, select Phone.
3.
In the Find and List Phones page, make sure the last text box is blank and click Find.
This will list all the IP phones connected to your system plus the CTI ports and Call Control groups
automatically created in Unified CM when you configured the CRS Application.
automatically created in Unified CM when you configured the CRS Application.
5. Configure the device pool
with the previously
configured Regions.
with the previously
configured Regions.
Specifies the voice codec to be used for calls
in the regions with the devices.
in the regions with the devices.
Device Pool Configuration window
See also the Cisco Unified Communications
Manager Administration Guide, "Device Pool
Configuration" chapter.
Manager Administration Guide, "Device Pool
Configuration" chapter.
From the Unified CM Administration page
menu bar, select Device > Phone and then
either find a configured phone or click the Add
New link.
menu bar, select Device > Phone and then
either find a configured phone or click the Add
New link.
Choose the device pool from the Phone
Configuration web page.
Configuration web page.
6. Configure the phones
individually in Unified CM
with the correct directory
numbers or configure them
with the Unified CM BAT
tool. For Bulk Configurtion,
associate the Device Pool
with the Phone
Configuration.
individually in Unified CM
with the correct directory
numbers or configure them
with the Unified CM BAT
tool. For Bulk Configurtion,
associate the Device Pool
with the Phone
Configuration.
Specifies a unique dialable phone number for
each phone.
each phone.
Also, defines characteristics for devices, such
as region, date/time group, failover behavior,
and others.
as region, date/time group, failover behavior,
and others.
You must set the configuration on each IP
phone so that it can locate and connect to
Unified CM . This procedure varies by site
according to the customer's network
configuration.
phone so that it can locate and connect to
Unified CM . This procedure varies by site
according to the customer's network
configuration.
Phone Configuration window or BAT
See also the Cisco Unified Communications
Manager Administration Guide, "Cisco Unified
IP Phone Configuration"section.
Manager Administration Guide, "Cisco Unified
IP Phone Configuration"section.
From the Unified CM Administration page
menu bar, select Device > Phone and then click
the Add New link. Next select your phone type
and click Next and continue to follow the
instructions, filling in the required information
in the Phone Configuration window.
menu bar, select Device > Phone and then click
the Add New link. Next select your phone type
and click Next and continue to follow the
instructions, filling in the required information
in the Phone Configuration window.
Add the phone number and a directory number
to the phone number, and then configure the DN
(Dialed Number).
to the phone number, and then configure the DN
(Dialed Number).
Table 5-1
Unified CM Configuration Check List (continued)
Task
Purpose
Configuration Location