Cisco CiscoWork QoS Policy Manager 4.1.2 User Guide
F-19
User Guide for QoS Policy Manager 3.0
78-12542-01
Appendix F CLI Command Reference for QPM Actions
Configuration on Catalyst Switches with Supervisor IOS
4.
mls qos trust {cos | dscp}
When you configure the trust state for Catalyst 3550 switches with Supervisor
IOS (no VLAN-based QoS), QPM uses this command sequence to configure the
device:
IOS (no VLAN-based QoS), QPM uses this command sequence to configure the
device:
1.
mls qos
2.
interface interfacename
3.
mls qos
4.
mls qos trust {cos | ip-precedence | dscp}
Marking Policies on Catalyst Switches with Supervisor IOS
When you configure marking policies for a Catalyst 6000 with Supervisor IOS,
QPM uses this command sequence to configure the device:
QPM uses this command sequence to configure the device:
1.
class-map [match all | match any] classname
a.
match [not] access-group ACLNum
2.
policy-map policy-map-name
class classname
trust {cos | ip-precedence | dscp}
When you configure marking policies for a class-default filter for a Catalyst 2950
with Supervisor IOS, or Catalyst 3550 with Supervisor IOS, QPM uses this
command sequence to configure the device:
with Supervisor IOS, or Catalyst 3550 with Supervisor IOS, QPM uses this
command sequence to configure the device:
1.
Switchport priority extend trust
2.
Switchport priority extend cos cos
When you configure marking policies for a user-defined filter for a Catalyst 2950
with Supervisor IOS, QPM uses this command sequence to configure the device:
with Supervisor IOS, QPM uses this command sequence to configure the device:
1.
class-map [match all | match any] classname
a.
match [not] access-group ACLNum
2.
policy-map policy-map-name
3.
class classname
4.
set ip dscp dscp