Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
Chapter 2 Installation and Configuration
GainMaker bdr 2:1 Optical Transmitter Module
7 Pull the transmitter out from the optical section.
a If you are not reinstalling the transmitter at this time, proceed to step 11.
b If you are reinstalling the transmitter now, proceed to step 8.
b If you are reinstalling the transmitter now, proceed to step 8.
8 Insert the transmitter in the appropriate slot and ensure that the transmitter is
seated properly.
Note: Insertion slot is labeled on the optical interface board.
Note: Insertion slot is labeled on the optical interface board.
9 Use a flat-blade screwdriver to tighten the two mounting screws.
10 Route the fiber pigtail through the fiber access slot.
10 Route the fiber pigtail through the fiber access slot.
Note: Route excess fiber loosely through the fiber hold-down clip.
38
OL-29644-03