Alcatel-Lucent omniaccess safeguard controller Installation Instruction
OmniAccess SafeGuard Controller Installation Guide
33
Chapter 2: Site Preparation and Installation
Figure 14 Connecting the Ethernet Management Port
Connect the serial console port using an RS-232 cable with a DB-9 connector, as shown in
. The default settings for this port are 9600 baud, 8 data bits, 1 stop bit, and no
parity or flow control (9600 8-N-1 none). The default settings may be changed either in
the boot monitor or during system operation.
the boot monitor or during system operation.
Figure 15 Connecting the Serial Console Port
CST_012
CST_015