Panasonic wv-cu360 User Manual

Page of 32
29
7. Move the cursor to [SPECIAL] on the Setup menu, and
press numeric buttons 
4
and 
6
simultaneously for 2
seconds or more to display the special menu.
8. Move the cursor to [CAMERA RESET]* on the Setup
menu, and press buttons 
4
5
and 
6
simultaneously to
cancel all the functions to the defaults.
The menu to reset the camera functions differs
depending on the camera:
[SPECIAL] for the WV-CS650, [SPECIAL 2] for the WV-
CS850, and [END] for fixed cameras etc.
Caution:
If camera setup is started using the buttons
on the camera, all future operations for setup must
be performed using the buttons on the camera.
If camera setup is started using the System
Controller, all future operations for setup must be
performed using the same controller.
Note:
For further information, refer to the Operating
Instructions for the selected camera.
Keys Used for camera with Setup Menu
[LEARNING] appears on the monitor.
3. Patrol play the combination camera by using the joy-
stick or zoom buttons etc. This enables the combination
camera to learn.
Maximum learning time is 30 seconds.
4. To stop the learning, press the 
SEQUENCE/PATROL
STOP
button while holding down the 
PROGRAM/CAM
SETUP/CAM FUNCTION 
button.
The learning program
• Pan/Tilt (Joystick)
• Iris (Open/Close)
• Focus (Far/Near)
• Zoom (Tele/Wide)
• Preset Position
Note:
The learning program differs depending on the cam-
era. For further information, refer to the Operating
Instructions for the camera to check the operations cov-
ered by the learning program before operating the cam-
era.
[LEARNING] disappears on the monitor.
LEARNING
2
8
4
6
To move the cursor.
To select a parameter.
To execute the mode or
To enter a submenu
To return to the previous menu
CAM
SET
MON
ESC
Camera Patrol Learning for Camera Patrol
Operation
There are two ways of setting camera patrol learning.
One is to set up using the Camera Setup menu and the
other is to set up while operating the camera.
Follow the procedures below to set up while operating a
combination camera.
1. Select the desired system unit, monitor and combina-
tion camera.
2. Press the 
PATROL PLAY/PATROL LEARN
button
while holding down the 
PROGRAM/CAM SETUP/CAM
FUNCTION
button.
PATROL PLAY
PATROL
LEARN
CAM FUNCTION
CAM SETUP
PROGRAM
SEQUENCE
PATROL
STOP
CAM FUNCTION
CAM SETUP
PROGRAM