Panasonic KXTCD220G Operating Guide
Useful Information
57
SMS (Short Message Service)
Answering system
While viewing caller information, the
display returns to standby mode.
display returns to standby mode.
L
Do not pause for over 1 minute while searching.
I cannot register a handset to a base
unit.
unit.
L
The maximum number of base units (4) are already
registered to the handset. Cancel unused base unit
registrations from the handset (Seite 49).
registered to the handset. Cancel unused base unit
registrations from the handset (Seite 49).
L
The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (Seite 49).
registered to the base unit. Cancel unused handset
registrations from the base unit (Seite 49).
L
You entered the wrong PIN number. If you forget your
PIN, consult your nearest Panasonic service centre.
PIN, consult your nearest Panasonic service centre.
L
Locate the handset and the base unit away from other
electrical appliances.
electrical appliances.
Problem
Cause & solution
I cannot send or receive SMS
messages.
messages.
L
You have not subscribed to the appropriate service.
Consult your service provider.
Consult your service provider.
L
The SMS message centre number(s) are not stored or
are incorrect. Store the correct numbers (Seite 33).
are incorrect. Store the correct numbers (Seite 33).
L
Message transmission was interrupted. Wait until the
message has been sent before using other telephone
functions.
message has been sent before using other telephone
functions.
L
“FD” is displayed.
L
The unit could not connect to the SMS message centre.
Confirm that the correct SMS message centre numbers
are stored (Seite 33). Confirm that SMS is turned on
(Seite 32).
Confirm that the correct SMS message centre numbers
are stored (Seite 33). Confirm that SMS is turned on
(Seite 32).
“FE” is displayed.
L
An error occurred while sending the message. Try again.
“E0” is displayed.
L
Your phone number is permanently withheld or you have
not subscribed to the appropriate service. Consult your
service provider.
not subscribed to the appropriate service. Consult your
service provider.
“Q” is not displayed after you read a
message. An error code (“FD”, “FE”,
or “E0”) is displayed.
message. An error code (“FD”, “FE”,
or “E0”) is displayed.
L
When an error code is displayed, “Q” will not be
displayed even if you have read the message.
displayed even if you have read the message.
Problem
Cause & solution
The other party complains that they
cannot leave a message.
cannot leave a message.
L
The recording time is set to “Nur Begrüßung”. Select
“1 Minute” or “3 Minuten” (Seite 46).
“1 Minute” or “3 Minuten” (Seite 46).
L
Message memory is full. Erase unnecessary messages
(Seite 43).
(Seite 43).
Problem
Cause & solution
TCD220G(e-g).book Page 57 Thursday, January 20, 2005 11:43 AM