Driven Designs Inc. PPS User Manual
Page 10
POOL PATROL PA-25 & PA-30
place the unit into an inactive mode. Turning the alarm right side up will
enable the processor and place the unit into a ready state.
If the alarm is sounding it will automatically reset after 3 minutes and
return to its ready state. To reset and turn off the alarm manually, lift the
alarm out of your pool, shake off the excess water around the sensing
ring and center post, and turn the alarm upside down (180º angle) for five
seconds.
enable the processor and place the unit into a ready state.
If the alarm is sounding it will automatically reset after 3 minutes and
return to its ready state. To reset and turn off the alarm manually, lift the
alarm out of your pool, shake off the excess water around the sensing
ring and center post, and turn the alarm upside down (180º angle) for five
seconds.
After the pool has settled (about 10 minutes) you can replace the pool
alarm in the pool.
alarm in the pool.
Resetting the pool alarm will not reset the receiver. After sounding, both
the transmitter and receiver will automatically reset after three minutes.
the transmitter and receiver will automatically reset after three minutes.
ALARM PLACEMENT
One pool alarm can be used for all pool types. This includes above-
ground, in-ground, inflatable and soft side pools.
ground, in-ground, inflatable and soft side pools.
Use the placement suggestions in Figure 5 to determine the best
placement for your pool shape.
placement for your pool shape.
Figure 5 Recommended placement for pools smaller than 20 x 40 ft.