Driven Designs Inc. PPS User Manual
Page 11
POOL PATROL PA-25 & PA-30
If your pool is larger than 20 x 40 ft. we recommend using more than one
pool alarm. Refer to Figure 6 for placement of more than one alarm.
pool alarm. Refer to Figure 6 for placement of more than one alarm.
Determine where in the pool the alarm will be placed. Remove the
string and clips included with the alarm.
string and clips included with the alarm.
Measuring from the center of the alarm, place the alarm approximately
12” to 18” inches from the side of the pool. From this position determine
where the tie-down locations will be. Cut the string to length and leave
approximately 2' of slack in the string for the alarm to function and be
12” to 18” inches from the side of the pool. From this position determine
where the tie-down locations will be. Cut the string to length and leave
approximately 2' of slack in the string for the alarm to function and be
removed easily. Tie down
locations should be as close to
the water level as possible for
the best results.
locations should be as close to
the water level as possible for
the best results.
Note: To keep the nylon string
from unraveling tie a knot in the
end or use heat to melt the
strands together.
from unraveling tie a knot in the
end or use heat to melt the
strands together.
Tie one end of each string to
each tab on the float (Figure 7).
Tie the other end of the stings to
each tab on the float (Figure 7).
Tie the other end of the stings to
each tie down location of the
pool. Do not place the alarm
pool. Do not place the alarm
any closer than one foot from the side of your pool. Leave
Figure 7 Float Tab
Figure 6 Recommended placement for pools larger than 20 x 40 ft.