Inscape Data Co. AGNVC110W User Manual
NVC100/110 User’s Manual
13
13
13
13 of
of
of
of 51
51
51
51
provided by your ISP.
5. Connect to NVC100/110 in Administrator Mode for initial parameter set-up.
All parameters are set to the factory default state when the NVC100/110 is delivered to
you. You are asked to configure the system for your environment in administration mode.
Detailed information for using the administration mode can be found in
you. You are asked to configure the system for your environment in administration mode.
Detailed information for using the administration mode can be found in
[5.
Configuring
the A/V Server in Administrative Mode]
. The parameters in the following table should
be set up with the proper values. Detailed information for the parameters in Administrator
Mode can be found in
Mode can be found in
[5.
Configuring the A/V Server in Administrative Mode]
[Note]
: Setup values are preserved even when the power is turned off.
Page
Parameter
Setup value
Factory default value
Video Size
Define the resolution of the
video transmission from the
NVC100/110.
Max Upload Rate
Set this value as smaller than
the upload speed of your
network.
Frame Rate
Indicates the number of frames
transmitted per second.
Basic Setup
Video Rate
Indicates the bandwidth allowed
for video transmitted from the
NVC100/110.
Make sure that you press the
Check button to find out the
number of maximum possible
simultaneous users, then set
the number of users as smaller
than or equal to that number.
User Admin
& Time
Setup
Administrator Name &
Password
For safety, it is
recommended that you change
these values from the factory
default. For a new connection,
you need to input the changed
values for the corresponding
fields. Do not share these
values with others, and
memorize them for safety.
Default value
Username: root
Password: dw2001
User Admin
& Time
Setup
Current Time
Input the correct time in this
field.
Default value:
2001/1/1
6. Connect the input and output signals to NVC100/110.