JTECH Communications Inc. SERIES2600 User Manual
JTECH UHF Desktop Transmitter Installation and Operation Guide 320115K
Page 30
Prompt Meaning
Display Pager?
Display the entries in the replace pager table. A # key
will move forward in the table and display the next entry,
while pressing the 0 key will back up the display to the
previous entry in the replace table. Use * to terminate this
mode at any point in the display.
will move forward in the table and display the next entry,
while pressing the 0 key will back up the display to the
previous entry in the replace table. Use * to terminate this
mode at any point in the display.
Add Pager to Group
A pager may be added to an existing group or a new
group may be started. You will be asked ‘Which Group?’
and ‘Which Pgr?’ The group can be 1 – 99 and the pager
number for the pager to be added to that group may be
from 1 -9990.
Groups 1 – 9 are preprogrammed in the factory. These
groups may have associated Dynamic (set up by the
PeopleAlert user) Groups and are both paged by the
same single digit group number. Groups 10 – 99 are
Dynamic Groups which the user sets up and alters as
needed.
group may be started. You will be asked ‘Which Group?’
and ‘Which Pgr?’ The group can be 1 – 99 and the pager
number for the pager to be added to that group may be
from 1 -9990.
Groups 1 – 9 are preprogrammed in the factory. These
groups may have associated Dynamic (set up by the
PeopleAlert user) Groups and are both paged by the
same single digit group number. Groups 10 – 99 are
Dynamic Groups which the user sets up and alters as
needed.
Remove Pg fm Group
This removes a pager from a Dynamic Group. Press #.
Enter the group number when requested by the ‘Which
Group?’ display and press # to go to the screen that asks
‘Which Pgr? Where the pager number to be removed is
entered. Pressing the # one more time completes the
removal and displays the conformation message ‘X out of
Gp. Y’.
Enter the group number when requested by the ‘Which
Group?’ display and press # to go to the screen that asks
‘Which Pgr? Where the pager number to be removed is
entered. Pressing the # one more time completes the
removal and displays the conformation message ‘X out of
Gp. Y’.
Display Group
This displays the pagers in a Dynamic Group in the l
order in which they will be transmitted. Press # to go
from one group member display to next. The * key will
terminate the Display mode.
order in which they will be transmitted. Press # to go
from one group member display to next. The * key will
terminate the Display mode.
Active Groups
This displays the Dynamic Group numbers for the groups
that have members. Pressing # advances to the next
group that has members. If a group is found and it is
desired to display its members, press 0 to go to the
Display Group mode as described above.
that have members. Pressing # advances to the next
group that has members. If a group is found and it is
desired to display its members, press 0 to go to the
Display Group mode as described above.
____ Removed
Entering a new pager number of 0000 caused the entry
for the old pager number to be removed from the replace
pager table.
for the old pager number to be removed from the replace
pager table.