Senstar Corporation E7BA0300 User Manual
Rev A
WGS Configuration
FlexZone Wireless Gate Sensor
Page 13
The following procedures assume that the FlexZone processor, the GSR and the GSM are
installed and operational, and that the FlexZone processor is configured.
installed and operational, and that the FlexZone processor is configured.
•
Ensure that the GSM is powered up (i.e., new battery installed, or at least 2 hours of sunlight
exposure for solar powered unit).
exposure for solar powered unit).
•
Once the GSM serial number is entered via the UCM and downloaded to the FlexZone
processor, it generally takes about 2 minutes for the GSM/GSR pairing process to complete.
processor, it generally takes about 2 minutes for the GSM/GSR pairing process to complete.
•
It is possible that an interference alarm may be generated when reassigning GSM serial
numbers, or when setting up a network. If the interference alarm persists, select a different RF
channel.
numbers, or when setting up a network. If the interference alarm persists, select a different RF
channel.
Gate sensor module setup
1.
Connect the UCM to the FlexZone processor.
Figure 14: GSM configuration window
GSM configuration tab
Enable checkbox
selectable RF channel
selectable relay for GSR fail notification
GSM selection tabs
enter the GSM Serial Number
high pass and low pass target filters
GSM detection parameters
selectable GSM supervision mode
selectable auxiliary device local bypass
selectable relays for GSM alarm,
supervision and diagnostic fault conditions
supervision and diagnostic fault conditions
selectable auxiliary device supervision
auxiliary device input parameters
selectable relay for auxiliary device alarm
and supervision
and supervision
specify the Locale (area of operation)
North America = FCC; Europe = ETSI
North America = FCC; Europe = ETSI