Digital Security Controls Ltd. 13WTK5504P User Manual

Programmable Attributes 

Supervisor Code

Remote Access

Duress Code

Bell Squawk upon Arming/Disarming

Zone Bypassing Enabled

One Time Use Code

Bell Squawk Attribute
This attribute is used to determine whether an access code should generate an arming/disarming Bell 

Squawk upon entry of the code for Away arming. The wireless keys with access codes associated with 

them may generate Arming/Disarming Bell squawks. If desired, this option may be used with codes that 

are manually entered. Please contact your installer to have this programmed.
NOTE: The Master Code cannot use the Bell Squawk attribute, but is required to enable it for 

access code assigned to a wireless key is manually entered at a keypad.
Setting an Access Code
1. Select “Set Access Code”. A keypad screen is shown with the existing code. If there is no exist-

ing code, “AAAA” (or AAAAAA for 6 digits) is shown.

2. Start to enter a new code. The code area will be cleared, and the new code will be shown. If the 

clear key is pressed, the new code will be cleared, but the old code is not deleted by this action. 
Once the last digit is entered the new code will have replaced the old code; no further action is 
required to save the code. If the screen “times out” (goes grey or black) or you exit the screen 
without completing the new code, the previous code will remain.

User xx settings > Prox Tag Programming
Enrolling Proximity Tags
1. Press the Access Code Programming button, then “Set Access Code”. 
2. Enter your desired 4- or 6-digit user access code.
3. Press Prox Tag Programming. 
4. Place the prox tag near the tag reader 

 at the top of the keypad to assign it to the user code. The 

message “Tag Enrolled Successfully” will be displayed and the keypad will beep. If the proxim-
ity tag has been enrolled previously, an error tone will sound. The screen will read “Duplicate 
Tag/User Code”.

NOTE: Prox tags do not work on PowerSeries panels.   
Erasing Prox Tags
Delete tags from the system when they are lost or no longer needed. To delete a proximity tag, the user 

code it is associated with must be deleted.
1. Press More > User Options > Access Code Prog. [Master Code].
2. Use left and right arrow buttons to select the user number associated with the proximity tag to be 

deleted and press Select.

3. L CE  LgEPEIELt ECLGAULOBArTCbLedLaCE  TA:L

, E  x 

Replacing Existing Prox Tags
To keep the same user code and number, but enrol a new tag due to loss of the old one 
1. Press More > User Options > Access Code Prog. [Master Code].
2. Use left and right arrow buttons to select the user number associated with the proximity tag and 

press Select.

3. Choose “Replace Prox Tag” from the menu options. 
4. Place the prox tag near the tag reader 

 at the top of the keypad. The message “Tag Enrolled 

Successfully” will be displayed and the keypad will beep.

User Options
Erasing an Access Code
To erase a code, select the code and choose Delete User. The system will delete the code immediately 

and the user will be returned to select another code.