Digital Security Controls Ltd. 163G4005 User Manual
40
Universal Cellular Communicator
Programming/Audio Import/Export
PSTN/PTM
This page refers to the “PTM (Panel Transmission Monitoring) function”, which allows the device to transmit calls over the GSM
network in the event of failed communication between the control panel and the receiver on the PSTN telephone line.
network in the event of failed communication between the control panel and the receiver on the PSTN telephone line.
The Communicator restores to normal mode after 5 minutes on the GSM channel.
The PTM function considers communication to have failed when:
It does not detect number dialling, if the “Check Dialling” option has been enabled (this option checks that telephone num-
bers have been dialled correctly).
bers have been dialled correctly).
It does not detect a kiss-off (the signal transmitted by the receiver when successful event communication has ended).
The kiss-off signal frequency is 1400 Hz in the CID protocol and 2025Hz in the SIA protocol.
All numbers are checked if the “Telephone Numbers” list is empty; otherwise only the numbers on the list will be checked.
Calls are transmitted over the GSM network when the programmed “PTM Max Errors Before Takeover” has been reached.
Primary Path
Primary Communication Path: select in this field the primary line GSM or PSTN.
Phone numbers with PMT function are programmed in the PhoneBook page.
Timeouts
LE Failure Timeout (sec.): enter the time in seconds (between 10 and 3600 seconds) for the Line down on the LE terminals,
before the PSTN Fault event occurs
before the PSTN Fault event occurs
The time may increase up to 60 seconds if some telephone devices are connected to the terminals LI.
LE Restore Timeout (sec.): enter the time in seconds (from 10 to 3600) that the telephone line must be connected to the LE
terminals before the PSTN Fault event is reset.
terminals before the PSTN Fault event is reset.
To comply with the EN50136-2:2013 standards the function “LE Restore Timeout (sec.)” must not be changed.
(default: 10 sec.)
(default: 10 sec.)
Import Audio Button - Press this button to import the recorded voice messages from a USB stick. The com-
municator will convert the file in the voice messages to use in the system.
municator will convert the file in the voice messages to use in the system.
Export Audio Button - Press this button to export the recorded voice messages on a USB stick. The com-
municator will convert them into a file that can be used on another system.
municator will convert them into a file that can be used on another system.
Import Programming Button - Press this button to import the communicator programming from a USB
stick. The communicator will convert the file into the programming to be used in system.
stick. The communicator will convert the file into the programming to be used in system.
Export Programming Button - Press this button to export the programming communicator on a USB stick.
The communicator will convert it into a file that will be used on another communicator.
The communicator will convert it into a file that will be used on another communicator.