Digital Monitoring Products Inc PC0096 User Manual

 

The four annunciator outputs can be programmed to indicate the activity of the panel’s zones or conditions

occurring on the system.  Annunciator outputs do not provide a voltage but instead switch-to-ground voltage 

from another source.  The outputs can respond to any of the conditions listed below:
1)  Activation by zone condition: Steady, Pulse, Momentary, or Follower

6)  Ambush alarm

2)  Manually from the keypad

7)  Exit and Entry timers

3)  Communication failure

8)  System Ready

4)  Armed area annunciation

9)  Late to Close

5)  Fire Alarm or Fire Trouble
 

The open collector outputs are accessible by installing the DMP 300 Harness on the 4-pin header labeled J11.

The output locations are shown below.  
 

1

Red

1

3

Green  3

2

Yellow

2

4

Black

4

Connect a Model 860 Relay Module to the panel to provide relays for the annunciator outputs that can be

used for electrical isolation between the alarm panel and other systems or for switching voltage to control 

various functions. The module includes one relay and provides three additional sockets for expansion of up

to four relays. Power is supplied to the relay coils from the panel keypad bus. The 860 mounts inside the

panel enclosure using the 3-hole mounting configuration. Plastic standoffs are provided with the module for

ease of installation. A 4-wire harness is also provided that connects the Model 860 to the panel.
Relay Contact Rating:  1 Amp at 30 VDC