Digital Monitoring Products Inc PC0096 User Manual

 

The Ethernet Connector (J1) is available on the Network version and connects directly to an Ethernet

network using a standard patch cable.

The two LEDs, located on the left side of the J1 Ethernet Connector,

indicate network operation. The top, Link LED is a steady green light

when an ethernet cable is connected. The bottom, Activity LED

flashes yellow to indicate messages are being received or transmitted.

The reset header is located just above the terminal strip on the right side of the circuit board and is used 

to reset the XT30/XT50 microprocessor. To reset the panel when first installing the system, install the reset

jumper before applying power to the panel. After connecting the AC and battery, remove the reset jumper. 
To reset the panel while the system is operational, for example, prior to reprogramming, install the reset 

jumper without powering down the system. Remove the reset jumper after one or two seconds.
After resetting the panel, begin programming within 30 minutes. If you wait longer than 30 minutes, you

must reset the panel again.

J3

Phone Line

Outputs

J11

1 

2 

3 

4

J1

Ethernet

J20

Wireless 

Antenna 

connection

J7 RJ 

Supervision

J24 Celllular 

header for 

263G 

connection

J19 Celllular 

Antenna 

connection

65555

Momentarily 

place the Reset 

jumper over both 

of the J16 pins to 

reset the panel.

J16

Reset

J18

Load

RED

Programming

J8

To update the XT30/50 panel with a new software version (ru file), place jumpers on the Reset (J16) and

Load (J18) headers. Connect a DMP 399 Cable from the J8 Programming Header to a laptop PC containing

the ru file. Then, remove the jumper from the Reset (J16) header while leaving the Load (J18) jumper in

place. 
After the software version is updated, return the jumper to Reset (J16), remove the Load (J18) jumper and

the 399 cable. Then remove Reset (J16) jumper to resume normal panel operation.

J1

Ethernet

Link LED

Activity LED