Digital Monitoring Products Inc PC0181 User Manual

 

Enable communication fail notification by selecting YES at COMM TRBL. Select NO 

to disable. Default is YES.

When COMM TRBL is YES and the panel detects a failure of communication, the 

panel sends an S72 (Comm Trouble) message through a backup communication 

method with notification of the failure. If both primary and secondary methods 

of communication fail, then two S72 messages will be sent via the third 

communication method, if programmed. The keypad sounds a continuous tone, 

which may be silenced by pressing any key, and displays “COMM  -TRBL”.

When communication is restored, the panel sends an S73 (Comm Restored) 

message through the primary communication. The “COMM -TRBL” message is 

removed from the keypad display and the keypad sounder is turned off, if no other 

trouble messages are pending.

Note: If the primary or secondary communication type is CELL, S72 and S73 

messages include the cell signal strength as a -dBm value.

Enter the first APN (Access Point Name). This allows an access point for cellular 

communication and is used to connect to a DNS network. The APN may contain two 

lines of 16 characters to equal 32 characters. Default is set to SECURECOM400.

Enter the second APN (Access Point Name). This works as a backup in case the first 

APN fails. The APN may contain two lines of 16 characters to equal 32 character 

Default is set to SECURECOM400.

Allows you to set the options for the first receiver the panel attempts to contact 

when sending reports. The XTLplus supports communication to two receivers.

YES enables Abort, Alarm, Alarm Restoral, Alarm Bell Silenced, Ambush, Exit Error, 

and System Recently Armed reports to be sent to this receiver. Default is YES.

YES enables Supervisory, Trouble, Trouble Restoral, Force Armed, Late to Close, 

and Fault reports to be sent to this receiver. Default is YES.

YES enables Opening/Closing, Code Changes, and Bypass reports by user to be sent 

to this receiver. Default is NO.

Enter 

YES to enable the Recall Test report to be sent to this receiver.

Enter the first (primary) IP address where the panel sends network or cellular 

information. Enter all 12 digits and leave out the periods. For example, enter IP 

address 192.168.0.250 as 192168000250. The periods display automatically.

The message is sent using first Cell APN and the first IP Address. If no 

acknowledgment is received, first Cell APN and the second IP address are used, 

followed, if needed, by second Cell APN and first and second IP addresses, 

respectively.

Enter the first IP port number to be used in conjunction with the first IP Address. 

The IP port identifies the port used to communicate messages to and from the 

panel. The default IP Port setting is 2001.

Enter the second (secondary) IP address where the panel sends network or cellular 

information. Enter all 12 digits and leave out the periods. For example, enter IP 

address 192.168.0.250 as 192168000250. The periods display automatically.

Enter the second IP port number to be used in conjunction with the second IP 

address. The IP port identifies the port used to communicate messages to and from 

the panel. The default IP Port setting is 2001.

COMM TRBL NO  YES

SECURECOM400
-

FIRST CELL APN

SECURECOM400
-

SECOND CELL APN

RECEIVER 1 PROG

ALARM

NO  YES

SPV/TRBL  NO  YES

O/C USER  NO YES

TEST RPT  NO  YES

FIRST IP ADDR 
000.000.000.000 

FIRST IP PORT
    

SECOND IP ADDR
000.000.000.000 

SECOND IP PORT