Digital Monitoring Products Inc PC0181 User Manual

Press the first select key to select TEST and the panel will attempt to verify 

connection of your system to the desired Wi-Fi network.

When successful, W/L SECURITY displays. Select the security type based on the 

network router programming. The default network security type is WPA-PSK. Press 

any select key to display the other security options. The available options are WEP, 

WPA, and NONE.

Press the first select key to choose WEP, press the second select key for WPA, press 

the third select key for NONE.

This option displays only if Comm Type is set to Wi-Fi and Security option is not 

set to NONE. Enter the key provided from the network router’s programming. WEP 

requires a network password of 10 characters (WEP64) or 26 characters (WEP128), 

using a combination of the number 0-9 and the letters A-F. WPA/WPA-PSK uses a 

custom key that allows 8 to 32 characters (See the chart above to enter lowercase 

or special characters). Press COMMAND to save the key.
Note: Depending on the security type, the key might take several seconds  

to process.

If the panel uses a dynamic IP address Select YES. When set to YES the panel 

operates in DHCP and will not use the Local IP Address number.

Enter the local IP address for the panel. The Local IP Address must be unique 

and cannot be duplicated on the network. The default local IP address is 

192.168.000.250.

Enter the local gateway address. The Gateway IP Address is needed to exit the 

local network. The default gateway address is 192.168.000.001.

Enter the local subnet mask assigned to the panel. The default subnet mask 

address is 255.255.255.000.

Enter the IP address of the DNS (Domain Name System) used by the panel to 

resolve domain names into IP addresses. The default address is 192.168.000.001.

Note: The DHCP programming in the panel must be set to NO.

Enter the programming port number. The programming port identifies the port 

used to communicate messages to and from the panel. The default Programming 

Port setting is 2001.

This section allows you to enter the information needed to send and receive 

messages directly to and from the panel via MyAccess™ text messaging using 

cellular communication. All of the name and password options below allow up to 

32 lowercase characters to be entered. The Destination addresses allow up to 48 

characters to be entered. System Name is displayed with initial caps.

The transmitted messages are:

Zone Alarms by Zone Name

Early to Close

Zone Troubles by Zone Name

AC Power Trouble and Restoral

Zone Bypass by User

System Low Battery

Arming (Closings) by User

Ambush

Disarming (Openings) by User

Abort, Cancel and Alarm Verified by User

Late to Close

Check-in by User

Late to Open

TEST

W/L SECURITY:
WPA-PSK  

      

W/L SECURITY:
WEP WPA NONE

W/L KEY:
*****************
W/L KEY: 

-  

 

DHCP   NO YES

LOCAL IP ADDR
      192.168.000.250

GATEWAY ADDR
      192.168.000.001

SUBNET MASK
      255.255.255.000

DNS SERVER
      192.168.000.001

PROGRAMMING PORT
 

           2001

MESSAGING SETUP