Digital Monitoring Products Inc PC0181 User Manual

This section allows you to define a 16 character alphanumeric name for the device 

number. If no name is entered, *UNUSED* is displayed.

To remove a keypad from the system, delete the device name by pressing any 

select key, then press the COMMAND key. The device name is now displayed as * 

UNUSED *.

Select YES to use a wireless keypad. Default is YES.

Enter the eight-digit serial number found on the wireless keypad.

Press any top row key to select the supervision time required for the device. Press 

COMMAND to accept the default time. Default is 240 minutes.

Press the select key under the required number of minutes. The device must check 

in at least once during this time or a missing condition is indicated for that device. 

Zero (0) indicates an unsupervised wireless keypad.

Note: When the panel is reset, panel is powered down and powered up, or 

programming is complete, the supervision timer restarts for all wireless keypads.

This section allows you to enter the information needed for Remote Command/

Remote Programming operation via Wi-Fi communication. A description of the 

Remote Options follows:

This option allows you to enter a code of up to eight digits for use in verifying 

the authority of an alarm or service receiver to perform a remote command/

programming session. The receiver must give the correct key to the panel before 

being allowed access. All panels are shipped from the factory with the Remote Key 

preset as blank.

To enter a new Remote Key, press any select key and enter any combination of up 

to 8 digits. The numbers you enter appear as asterisks. 

Press COMMAND.

Enter YES to allow DMP service technicians to access the panel when required 

during system service or troubleshooting. This authorization automatically expires 

within one hour.
DMP remote service is provided on a read only basis: DMP technicians can look at 

the system programming and make suggestions only.

Enter YES to enable remote commands and programming to be accepted from the 

alarm SCS-1R Receiver. The Remote Key option can also be required.
When YES is selected, the panel requests the alarm receiver key during its first 

alarm communication with the first SCS-1R receiver. The panel retains this alarm 

receiver key in memory and allows remote commands to be accepted from the 

alarm receiver. If an alarm occurs during a remote connect, the alarm report is 

immediately sent to this receiver only.
When NO is selected, remote commands and programming are not accepted from 

the alarm SCS-1R receiver.

YES enables remote commands and programming to be accepted from a secondary 

service receiver other than the alarm SCS-1R Receiver. The Remote Key option can 

also be required.
With YES selected, the panel requests the service receiver key the first time it is 

contacted by the service receiver. The panel retains this service receiver key in 

memory and accepts remote commands from the service receiver.

* UNUSED *

WIRELESS? NO YES

 

SERIAL#: XXXXXXXX

 

SUPRVSN TIME: 240

 

SELECT MINUTES:
 0            60      240

REMOTE OPTIONS

RMT KEY:

MFG AUTH  NO YES

ALR RCVR  NO YES

SVC RCVR  NO  YES