Digital Monitoring Products Inc PC0181 User Manual

 

 

Select YES to allow the panel to send messages to three programmed destinations. 

Default is NO.

 

Enter a unique name for the panel. The panel name is used as the sender of the 

message. The text entered is displayed with initial caps. If this field is left blank, 

the panel account number is sent.

Enter the first cell phone number where text messages will be sent. The message can 

be sent to any device (computer or cell phone) as long as a valid cell phone number  

is entered.

Enter a valid, previously-programmed user number. This option is used when sending 

commands such as arming or disarming back to the pan el using MyAccess™ SMS Text from 

the same cell phone. The user number must have the authority to perform the commands 

as if it occurred at the keypad. Entering 0 (zero) disables this option. Default is 0.

Enter the second destination cell phone number.

Enter a valid User Number for arming/disarming authorization.

Enter the third destination cell phone number.

Enter a valid User Number for arming/disarming authorization.

 

Select YES to allow the panel to send Opening and Closing messages to a cell phone 

via SMS protocol. Default is NO. This option appears only if any destination above is 

a cell phone number.

 

This option displays if any programmed destination is a cell phone number using 

CELL communication. This number limits the monthly incoming and outgoing SMS 

messages allowed to be sent or received by the panel.

A panel event that causes messages to be sent to destination cell phone numbers 

is counted towards the panel’s monthly limit. For example, if an alarm message 

is sent to a cell phone number, a total of 2 messages are counted towards the 

monthly limit for the panel. SMS messages sent from a cell phone to the panel, 

including status requests and MyAccess™ SMS Text messaging commands, also 

count toward the monthly limit. The limit is reset at midnight on the 14th of every 

month. Range is from 0 to 999. When 0 is entered, there is no limit on the number 

of messages able to be sent or received by the panel. Default is 0.

Note: The SecureCom Wireless text plan selected for the panel should match or 

exceed the programmed Monthly Limit.

This section allows you to define the XTLplus panel wireless keypad configuration. 

You can install and address up to four wireless keypads.

Enter the device number of the wireless keypad you are programming. The valid 

range is 2-5.

Note: Address one is reserved for the XTLplus programming keypad attached  

during programming. After you program each option for the first keypad, repeat 

these programming steps for each additional keypad.

ENABLE MESSAGING
                  NO YES

SYSTEM NAME
-

DESTINATION 1
-

 

DESTINATION 1
USER NUMBER: 0

DESTINATION 2
-

 

DESTINATION 2
USER NUMBER:

0

DESTINATION 3

 

DESTINATION 3
USER NUMBER:

0

O/C SMS  NO YES

MONTHLY LIMIT: 0

DEVICE SETUP

DEVICE NO:-