Digital Monitoring Products Inc PC0181 User Manual

output number extends battery life, but response time may be up to 15 seconds. 

A fast response output number responds within 1 second, but reduces battery life. 

Refer to the specific wireless output installation guide to determine battery life.

This section allows you to define a 16 character alphanumeric name for any 

wireless output.

An output that is not part of the system must be marked * UNUSED *. To mark an 

output unused, press any select key to display the default name, then press the 

COMMAND key. The pro grammer auto matically pro grams the name  

as * UNUSED *.

Enter the eight-digit serial number found on the wireless device.

This message displays when the serial number is already programmed for another 

output or zone. The programmed output or zone number displays.

Press any top row key to select the supervision time required for the wireless 

output. Press COMMAND to accept the default time. Default is 240 minutes.

Select the required number of minutes. The transmitter must check in at least 

once during this time or a missing condition is indicated for that zone. 1100 Series 

transmitters automatically check in based on the supervision time selected for 

the wireless zone, no additional programming is needed. Zero (0) indicates an 

unsupervised transmitter.

The 3 minute supervision time is only available if using an 1135 or 1135DB  

Wireless Siren.

Note: When the panel is reset, a receiver is installed or powered down and 

powered up, or programming is complete, the supervision timer restarts for all 

wireless outputs.

This option displays when the wireless device is an 1135 or 1135DB wireless siren. 

Select YES to have the 1135/1135DB wireless siren follow the panel bell output. 

Default is YES.

This section allows you to assign functions to individual areas for XTLplus panels. 

All non-24-hour zones must be assigned to an active area. See the section on  

Zone Information.

Activate an area by assigning it a name. A name is given to each active area to 

assist the user during arming and disarming.

Enter the number of the area to program. In an area system, select from  

areas 1 to 6. 

In an All/Perimeter system, select INTerior or PERIMeter. 

In a Home/Away system, select INTerior, BDRM, or PERIMeter.

In an area system, enter up to 16 characters for the area name. Only those areas 

given names can have zones assigned to them. All others are marked *UNUSED*.

To add an area name to the system, press any select key and then enter up to 16 

characters for the new name. Refer to the Entering Alpha Characters section. Press 

COMMAND to continue.

To mark an active area as unused, delete the old name by pressing any select key 

then press the COMMAND key. The panel automatically sets the name as *UNUSED*. 

If you have already Initialized the panel, all areas will be marked as *UNUSED*. See 

section 2.3.

Select YES to allow this area to arm automatically according to the opening and 

closing schedule.

If Closing Check is selected as YES, the automatic arming does not take place  

* UNUSED *

SERIAL#: -

ALREADY USED:  ZXX

SUPRVSN TIME:  240

0       3      60    240

 

TRIP WITH PANEL
BELL

 NO YES

AREA INFORMATION

INT     

  PERIM 

AREA NO: -

INT     BDRM    PERIM

* UNUSED *

AUTO ARM  NO YES