UTC Fire & Security Americas Corporation Inc 723-TCVR User Manual

3

Concord Panel Wiring

3.

Insert a support standoff shown in Figure 4 (supplied 
with panel) into the panel circuit board location shown 
in Figure 5.

4.

Slide the module back-plate into the two top mounting 
clips located on the top-right side of the cabinet and 
onto the right-side support on the cabinet 
(see Figure 5).

5.

Push the lower-left corner of the module onto the sup-
port standoff (see detail in Figure 5).

1.

Loosen the inside terminals of the left and right 
antenna terminal blocks (see Figure 1).

2.

Insert an antenna into each inside terminal. (Insert 
antennas through cabinet top holes when module is 
mounted inside panel cabinet.)

3.

Tighten the antenna terminal screws.

This section describes how to wire the receiver module to 
Concord panels.

1.

Disconnect the panel power transformer and backup 
battery.

2.

Wire the module to the panel power and bus terminals 
as shown in Figure 6.

If you are mounting the module in its own plastic and not 
mounting it inside a cabinet, you may want to add cover 
tamper detection.

To do this, install a UL listed 1/4-inch press-fit reed switch 
on the module back-plate and wire the switch to any unused 
panel, HIM, or SnapCard ™ zone input terminals. Once 
programmed, if someone opens the module cover, the 
tamper switch opens and causes an alarm.

The reed switch holder and magnet clip are located at the 
bottom of the back-plate (see Figure 1 for details).

To install the tamper reed switch (Figure 7):

1.

Slide the reed switch into the reed switch holder 
located on the module back-plate as shown in Figure 7.