Unique Broadband Systems Ltd. DRU2KW User Manual
Page 46
X75 SERIES - Mk3 Controller
INSTALLATION & OPERATING MANUAL
Manual No. x75mk3-11
x75-man-Rev11-0815.indd
13.6 Network Settings
Clicking on Network Settings loads to Controller Network Settings page. This page
is used to setup the Ethernet and E-Mail communications settings.
Figure 28 - Network Settings WEB Applet (typical)
13.6.1 - Ethernet settings
The following settings set up the Ethernet interface.
IP Address
– Use the spinner controls or directly enter values into the boxes to
configure the controller IP address. Default is 192.168.0.200
Subnet Mask – Use the spinner controls or directly enter values into the boxes to
Subnet Mask – Use the spinner controls or directly enter values into the boxes to
configure the controller subnet mask. Default is 255.255.255.0
Gateway IP Address – Use the spinner controls or directly enter values into the
Gateway IP Address – Use the spinner controls or directly enter values into the
boxes to configure the controller Gateway IP address. Default is 0.0.0.0
Primary DNS
Primary DNS
– Use the spinner controls or directly enter values into the boxes to
configure the controller primary DNS. Default is 0.0.0.0
Secondary DNS
Secondary DNS
– Use the spinner controls or directly enter values into the boxes
to configure the controller secondary DNS. Default is 0.0.0.0
Host Name
Host Name
– Enter the host name into this box. Default is blank.
Mac address – Displays the MAC address of the controller.
Enable DHCP – If checked, the controller will communicate with a DHCP server
Enable DHCP – If checked, the controller will communicate with a DHCP server
to obtain the network settings.