Eurolite Superstrobe 2700 52202176 Data Sheet

1

2

3

4

5

6

7

8

9

10

ON

1

2

3

4

5

6

7

8

9

10

ON

• Connect the port DMX IN with the output of the DMX controller.

• Use a screened XLR cable. The controller must have at least two free control channels.

• Connect DMX OUT with the DMX input of the subsequent device. If the DMX stroboscopic flash effect is the last

or only device in the DMX chain, plug in a plug with terminators here.

The pin assignment of the connection sockets is imprinted on the device.

The DMX stroboscope flash device can be controlled with the installed controller (music control via microphone or
automatic operation) or with an external DMX controller.

• Switch all DIP switches to „OFF“.

• This activates the music control. The stroboscope flashes with the beat of the music.

• Switch the DIP switch 10 to „ON“. All other DIP switches must be set to „OFF“.

• The stroboscope flashes permanently.

Each DMX device in a DMX chain requires a so-called start address to be clearly identified by the controller.

This start address is defined by the DIP switches 1 to 9 on the device.

Each DIP switch is assigned a value. The total of these values then defines the start address.