Eurolite Superstrobe 2700 52202176 Data Sheet

Product codes

52202176

Maintenance

Regularly check the technical safety of effect beamer, for example, for damage to the mains cable or the housing.

The protective disk must be exchanged when it shows visible damage and its effectiveness is impaired, e.g. through
cracks or deep scratches.

If you have a reason to believe that the device can no longer be operated safely, disconnect it immediately and secure
it against being operated unintentionally. Pull the power plug out of the socket outlet !

It can be assumed that safe operation is no longer possible if:

• the device shows visible damage, especially when the protective disk is damaged

• the illuminant is damaged or has deformed through heat

• the device no longer works

• it has been stored for a long time under unfavourable conditions

• it was exposed to extraordinary stress caused by transport

Always observe the following safety instructions before cleaning or servicing the effect beamer:

After switching off the device wait at least 20 minutes before opening it!

Live components may be exposed if the covering is opened or components are removed.

Prior to start of maintenance or repair works, the device must be disconnected from all voltage
sources.

Capacitors inside the device may still carry voltage even though they have been disconnected
from all voltage sources.

Repairs may only be carried out by qualified personnel who are familiar with the hazards
involved and the relevant regulations.

Cleaning

The outside of the light effect should only be cleaned with a soft, dry cloth or brush.

Never use aggressive cleaning agents or chemical solutions as these may damage the surfaces of the housing.

Changing the light bulb

The illuminant has a very long service life. Should you still have to exchange the illuminant at some point, you have
to open the casing. This work may only be carried out by specialists familiar with the hazards involved and with the
relevant regulations.