Bosch Appliances Home Security System D9412GV2 User Manual

D9412GV2/D7412GV2 | Operation and Installation Guide | 13.0  

Programmer and Accessory Connections 

. 

 

Bosch Security Systems, Inc. | 5/05 | F01U003641B 

61 

 

13.0  Programmer and Accessory 

Connections 

13.1 Programmer 

Connector 

Refer to the D5200 Operation Manual  
(P/N: 74-06176-000) for complete information on using 
the D5200 programmer.  

To connect and disconnect the programmer: 
1.  Lock the Reset Pin (Figure 30). 
2.  Connect the D5200 Data/Power cord to the 
programming connector on the control panel 
(Figure 31). 
3.  Perform the desired programming function (send 
or receive program). 
4.  Disconnect the programmer. 

 

Figure 30:  Reset Pin 

1

2

 

 

13.2  Programmer Access Reports 

When a program is sent to the control panel, the 
control panel sends a 

Prog Access OK

 report 10 

seconds after the handler exits or when the 
programmer disconnects. The prompt in routing must 
be programmed 

Yes to send this report. 

13.3 Accessory 

Connector 

Use the accessory connector to connect the control 
panel to the D928 Dual Phone Line Switcher. The 
accessory connector is on the bottom right corner of 
the I/O board (Figure 31). The D928 lets the control 
panel use two telephone lines to send reports. 

Refer to Section 7.11 D928 Dual Phone Line Switcher on 
page 29 for installation and operating instructions. 

Figure 31:  Programmer and Accessory 

Connections 

1

2