Bosch Appliances DVR DVR4C User Manual
Bosch Security Systems | Version 1.1
DVR4C | Installation Manual | Menu system
EN | 18
>> MONITOR SETUP
>>> DISPLAY CAMERA WITH MOTION
•
Select if the DVR switches automatically to a full
screen image of the camera when motion is detected
on that camera.
•
With multiple motion detections shortly after each
other, the last camera where motion was detected is
used for display.
>>> DISPLAY CAMERA WITH INPUT ALARM
•
Select if the DVR switches automatically to a full
screen image of the camera when an input alarm
becomes active for that camera.
•
In case of multiple input alarms shortly after each
other, the last input alarm is used for display.
>>> DISPLAY DWELL TIME
•
Specify the dwell time for displaying the camera
with an input alarm or motion. The interval can be
configured with a slider from 5 to 10 seconds.
•
If Follows is selected, the camera of the channel in
alarm or with motion is shown for as long as the
alarm is present or motion is detected.
>>> SEQUENCE DWELL TIME
•
Specify the sequence dwell time that is used when
the SEQ key is pressed.
•
The interval can be configured with a slider from Off
(disable) to 60 seconds (default 10 seconds).
>>> EXIT PLAYBACK ON EVENT
•
When set to On, the DVR exits playback to display a
live event.
>> SECURITY
>>> LOCAL PASSWORDS
•
Set a local user password to allow a user limited
access rights only for monitoring, monitoring control
(Auto Seq., digital zoom), copy and playback
control. Configuration is not allowed.
•
A password consists of 4 digits (0-9), entered by
using the up and down keys.
•
To confirm the input, the user has to enter the same
password again.
•
The configured password is only valid for local
users. The password is shown in the menu using *
characters.
•
If a password is set, a user without the correct
password can only view live video and switch
between full screen or quad views.
•
Set a local administrator password. An administrator
is allowed to enter all menus and configure all
settings.
•
A password consists of 4 digits (0-9), entered by
using the up and down keys.
•
To confirm the input, the administrator has to enter
the same password again.
•
The configured password is only valid for the local
administrator. The password is shown in the menu
using * characters.
•
To lock the keys on the front of the DVR, set keylock
to On and enter a four-digit password. (To unlock all
the keys on the front panel, use Keys 1 to 4 to enter
the password.)