Bosch Appliances DVR DVR4C User Manual

Bosch Security Systems | Version 1.1

DVR4C | Installation Manual | Menu system

EN | 19

>>> REMOTE USERS

•

and administrator can be specified here.

•

The administrator login name is always "admin" and

cannot be changed.

•

The remote user login name can be upto 16

characters long. The remote user password can be up

to 12 characters long.

•

Access to playback (PB) and relay control (RL) is set

for each remote user by placing a Y (allowed) or a N

(not allowed).

•

Even if remote relay is enabled, relays 1 and 2 cannot

be controlled via the remote software as they are

already used for input alarms, motion and system

failures.

•

Set Remote Setup to Enable (default) or Disable.

When set to Disable, configuration is possible only

via the front panel. PC users cannot configure the

DVR with the remote configuration software. When

set to Enable, both local and remote users can

configure the DVR.

•

Set IP Filtering to On to restrict access to the IP

address list set up by the Configuration Tool

application.

>> TIME SYNC

This setting is used for time synchronization over the

network. DVRs can be synchronized by setting them up as a

client for an SNTP server. The DVR can also be set up to act

as a local time server, when it is configured in SNTP server

mode.

>>> NETWORK TIME SERVER

•

Select On to allow the DVR to synchronize time

either as a client or as a master.

>>> SERVICE MODE

•

Select Client to allow the DVR time setting to be

synchronized by a network time server.

•

Select Master to allow the DVR to act as a network

time server and send its time to other DVRs to

synchronize them.

>>> SERVER IP ADDRESS

•

Enter the IP address of the network time server.

•

This network time server can be either a different

DVR, a computer or a server in the network. The

time is checked and synchronized with the network

time server once every hour.

>>> SYNCHRONIZE

•

When this button is pressed, the time is synchronized

with the network time server and other DVRs

immediately.

>> BEEPER

Select whether the beeper should sound when videoloss is

detected or an input alarm is activated. Select On (default)

or Off. When an input alarm or videoloss occurs, it sounds

for as long as the specified relay dwell time.