Panasonic PT-AE8000U User Manual

80 - ENGLISH

• 

When [BLANK] is activated, output is 12 V. If the 

setting is released, output is 0 V.

• 

Receives commands (



 page 103) from external device 

and outputs 12 V.

 

z

• 

If the trigger input signal from the external device is 

changed from 0 V to 12 V, the projector power will be 

switched on. And if it is changed from 12 V to 0 V, the 

power will be switched off.

• 

If the trigger input signal from the external device is 

changed from 0 V to 12 V, the screen will go blank. And 

if it is changed from 12 V to 0 V, the [BLANK] setting 
will be released.

 

z

The delay time can be set to 2, 4, 6, 8, 10, 20, and 

30 seconds.

 

z

It is possible to delay the trigger output signal (12 V) 

by the amount of time set. (Only available if trigger 

output item is selected.)

E.g.)  Select [SELECT 4:3 ASPECT] of the trigger output 

function and set the delay time to 10 seconds.

 

  Set the [ASPECT] in the [POSITION] menu to [4:3], 

and 12V is output from the trigger port after 10 
seconds.

 

z

You should not use trigger terminal output as the power 

source for other devices.

 

z

The projector will not accept trigger input while preparing 

to project after the power has been switched on and 

while preparing to shutdown after projection. Input trigger 

signals after projection starts or after entering standby 

mode.

 

z

12 V cannot be output from the trigger terminal when the 

projector is in standby mode.

Set the time for the power to be automatically turned 

off.

Inactive

Turn power off after 60 minutes

Turn power off after 90 minutes

Turn power off after 120 minutes

Turn power off after 150 minutes

Turn power off after 180 minutes

Turn power off after 210 minutes

Turn power off after 240 minutes

 

z

The projector automatically enters power off preparation 

mode (the power indicator illuminates orange), and then 

enters standby mode (the power indicator illuminates or 

flashes in red). (



 page 28)

 

z

3 minutes before turn-off, the number of minutes 

remaining will be displayed in the lower right corner.

 

z

If [SLEEP] mode is set to [OFF] mode before the 

specified time has elapsed the settings are erased.

Set to [ON] when using at locations between 1 400 m 

(4 593 ft) and 2 700 m (8 858 ft) above sea level.

When using at an altitude of less 

than 1 400 m (4 593 ft) above 

sea level

When using at high altitudes 

(between 1 400 m (4 593 ft) and  

2 700 m (8 858 ft) above sea 

level)

 

z

The fan rotation and operating noise increases if set to 

[ON].