Hampton Direct H35-NG1 Manual De Usuario

8

Hampton

®

 H35 Direct Vent Freestanding Gas Stove

 
When selecting a location for your stove, ensure 
that the clearances listed above are met as well 
as ensuring that there is adequate accessibility 
for servicing and proper operation.

1)  Ensure that structural members are not cut 

or weakened during installation.

2)  Ensure proper grounding using the #8 

ground lug provided.

3)  Appliance must be anchored to the fl oor 

with the supplied anchoring methods. 

The combustion air from this appliance is drawn 
from outside the building through the outer fl ue. 
Extra provision for combustion air inside the 
room is not required.

A) Cross 

Corner 

B) Room 

Divider

C) Island 

 

D) Flat 

on 

Wall

E) 

Flat on Wall Corner 

F) 

Flush with Wall/Alcove

For Vent Termination requirements, see the 
"Exterior Vent Terminal Locations" section.

Qty. Description
1  

 

Fan Speed Controller with nut, and  

 knob.

1  

 

Fan Assembly c/w green wire   

 attached 

1  

 Power 

cord 

 

1  

 

Plastic locking grommet

 
1)  Remove the Top Control Panel Assembly 

by removing the three screws. Diagram 1.

2)  Remove the nylon hole plug from the control 

panel.

3)  Install the fan speed controller onto the 

control panel and secure with nut. Connect 
remaining wire harness wires to speed 
control.  NOTE: Speed control wires must 
be in the down position when control panel 
is in place.

4)  Push black knob onto speed control.

5)  Remove the rear access panel on the back 

of the stove by removing the 6 screws. Install 
the fan onto pins as per Diagram 2.

 
 

 
6)  Push power cord through hole in the rear 

panel 14" - 16" and tie a loose knot in the 
cord on the inside to prevent the power cord 
from being pulled out. Diagram 2.

7)   Install locking grommet to power cord and 

push through hole in the rear panel and give 
a 1/4 turn to secure.

8)  Run green ground wire from fan and connect 

to grounding lug.

9)  Connect green power cord ground wire to 

grounding lug. 

10) Run the neutral black wire from power cord 

and connect to fan motor.

11)  Run the live black wire from power cord and 

connect to  speed control wire.

12) Connect the white wire of the wire harness 

to the fan terminal.

 

13) Ensure all wires are pulled away from fi rebox 

to avoid excessive heat and secure with 
stick-on wire clip.

14) Re-attach control panel with 3 screws, re-

versing step 1. Re-attach rear access panel 
with 6 screws, reversing step 5.