Cisco Systems 7500 Series Manual De Usuario

R E V I E W D R A F T — C I S C O C O N F I D E N T I A L

3-26

Cisco 7500 Series Installation and Configuration Guide

OL-5008-03 B0

Chapter 3 Installing a Cisco 7500 Series Router

Installing the Cisco 7513, Cisco 7513-MX, and Cisco 7576

Step 4

Replace the card cage assembly. (See the procedure in the

Step 5

Replace the power supplies. (See the

Step 6

Replace the processor modules in the card cage. (See the procedure in

.) Check all ejector

levers and ensure the processor modules are securely installed; tighten any that are loose.

This completes the procedure for installing the Cisco 7513, Cisco 7513-MX, and Cisco 7576. Proceed
to the

Attaching the Cisco 7513, Cisco 7513-MX, and Cisco 7576 Cable-Management
Bracket

Use the following procedure to install the cable-management bracket. You will need a large flat-blade
screwdriver for this procedure.

Step 1

Locate the two slotted screws between the blower module and the card cage opening at the interface
processor end of the router. (See

Figure 3-16

Installing the Cable-Management Bracket on a Cisco 7513, Cisco 7513-MX, and
Cisco 7576

Step 2

Loosen these two screws using the flat-blade screwdriver.

Step 3

Place the bracket over the screws, as shown in

Step 4

Tighten the screws.

122372

Loosen
screws (2)

Bracket

Blower
module

Card cage