GarrettCom 6K16V Manual De Usuario

Magnum 6K16V Managed Fiber Switch         Installation and User Guide (06/04)

 

removing the transceiver, press the clips on either side of the transceiver at the same time 

and pull the transceiver out. 

Each port has an Activity (ACT) LED indicating packets being received and a 

Link (LK) LED indicating proper connectivity with the remote device when lit. 

The Magnum GBIC-LXSC is a single-mode Gigabit fiber connector equipped 

with SC type connectors and can be easily snapped in and out. The Gigabit fiber ports are 

most popular as server-to-switch and switch-to-switch applications. It supports cable 

distances up to the IEEE 802.3z standard 1000Mbps distance limits, i.e., 10,25, 40 or 

70Km at full duplex, and depend upon the Gigabit modules used. 

 

 

 

 

 

               1@ 1000Mb Fiber SC + 2@ 100Mb SC   

The two Giga port has been offered as GBPM-2OTX (fiber or RJ-45), whereas the single 

Gigabit module comes in flavor of G+4(10/100 RJ-45 ports) or G+2 (100Mb fiber ports) 

as shown below in the above figure. 

Each port has an Activity (ACT) LED indicating packets being received and a link (LK) 

LED indicating proper connectivity with the remote device when lit.   

5.2.12 6KM-BLNK 

 

The 6K8-BLNK is a blank face plate or cover plate that must be installed in 

any empty 6K16V PM slot to 

maintain proper cooling air 

flow, safety, etc. 

 

 Two 

screws 

underneath the front panel hold 

the 6KM-BLNK in place.     

 

47

.

.