GarrettCom DS60s Manual De Usuario

Magnum DS50 / DS60s Dual Speed Hubs                  Installation and User Guide (06/02)

 

SC type (single-mode or multi-mode) 
 

The Fast Ethernet fiber 

switched port on the Magnum DS60F is 

set to operate at fixed 100Mb speed for 

guaranteed high performance. The 

DS60F’s fiber port is factory-built and 

available either as a multi-mode SC, or 

a single-mode or long-reach SC connector. The 100Mb fiber port will run at 100Mbs speed at 

all times with manually selected full- and half-duplex capability. The 100Mbps fiber port is a 

switched port and performs as a separate traffic domain, providing a high bandwidth backbone 

connection (no media converter is required !) and supporting long (up to 40km) fiber cable 

distances for installation versatility. 

Port 6 (the fiber port) has an “F - H” user-selectable manual switch. When set in the 

“F” position, it forces full-duplex mode. When set in the “H” position, it forces half-duplex 

mode, still at 100Mbps speed. 

On Magnum DS60F units, there are three LED’s for the switched ports.  One (LK) is 

steady ON to indicate LINK is operational.  The speed (100) LED is ON for 100Mbps and OFF 

for 10Mbps (when LINK is made). The F/H indicates full-duplex when ON.  When it is OFF, 

operation is half-duplex.  

A fiber cable must be connected to the 100Mb port and a proper link (LK light) must be made 

with the device at the other end of the cable in order for these LEDs to provide valid indications 

of operating conditions. 

 
2.2.3 

 

The Magnum DS60C chassis 

houses one main board for the five hub ports 

and for the switched port.  It has an internal 

power supply and a small cooling fan in the 

bottom. The front side of chassis consists of  

COL

PWR

1

2

3

4

5

6

RX

FDX

100

LK

10/100 Mb/s

FF-A

 

         Magnum DS60C Dual-speed Hubs Plus 

8 

.

.