Wagner SprayTech 7000 Manual De Usuario

Move the spray gun evenly during the spraying process. If this 

is not observed, an irregular spraying appearance will be the 

result. Carry out the movement with the arm, not with the 

wrist. A parallel distance of approx. 30 cm between the tip and 

the surface to be coated should always be observed.  The lat-

eral limitation of the spray fan should not to be too distinct. 

The edge of spraying should be gradual to facilitate overlap-

ping of the next coat. The spray gun should always be held at 

an angle of 90° to the surface to be coated. A spray fan aimed 

obliquely at the surface to be coated leads to an unwanted 

spray cloud.

Depending on the material, the use of a 

smaller nozzle size or fewer guns can impro-

ve the spray pattern when using multiple-

gun operation. 

To achieve perfect surfaces at varnishing works, special acces-

sories are available at Wagner, e.g. FineFinish tips or an AirCoat 

gun set. Your Wagner dealer will advise you.

The high-pressure hose is to be handled with care. Avoid sharp 

bending or kinking. The smallest bending radius amounts to 

about 20 cm.

Do  not drive over the high-pressure hose. Protect against 

sharp objects and edges.

Danger of injury through leaking high-

pressure hose. Replace any damaged high-

pressure hose immediately.

Never repair defective high-pressure hoses 

yourself!

When using the high-pressure hose while 

working on scaffolding, it is best to always 

guide the hose along the outside of the scaf-

folding. 

The unit is equipped with a high-pressure hose specially suit-

ed for diaphragm pumps.

Only use WAGNER original-high-pressure 

hoses with internal heating in order to ensure 

functionality, safety and durability.

Longer hoses (30 m is optimal) reduce vibra-

tions.

1.  Turn pressure regulating knob three revolutions to the 

left.

2  Open relief valve (2)

 

valve position   

   (circulation)

3.  Switch off the unit

4.  Pull the trigger guard on all spray guns in order to safe-

ly relieve the pressure of high-pressure hoses and spray 

guns.

5.  Secure the spray gun, refer to the operating manual of the 

spray gun.

6.  Remove tip from tip holder and store the tip in a small ves-

sel with suitable cleaning agent. 

7.  Leave the suction system immersed in the coating mate-

rial or immerse it in the corresponding cleaning agent. 

The suction filter and unit should not dry out.

8.  Cover the material container in order to prevent the paint 

from drying.

When using quick-drying or two-component 

coating substances, always flush the device 

through with a suitable cleaning agent with-

in the processing time, as otherwise it will be 

difficult to clean.

s pr ay Ing  techn Ique  / h andl Ing  the  h Igh-pressure  hose  / Interrupt Ion  of  w ork