Wagner SprayTech 7000 Manual De Usuario

dIspl ays  at  the  un It  / c lean Ing  the  un It

A clean state is the best method of ensuring operation with-

out problems. After you have finished spraying, clean the unit. 

Under no circumstances may coating material rests dry and 

harden in the unit. The cleaning agent used for cleaning (only 

with a flash point above 21 °C) must be suitable for the coat-

ing material used.

•  Secure the spray gun, refer to the operating manual of 

the spray gun.

 

Remove and clean the tip and tip guard.

1.  Open relief valve

 

valve position   

   (circulation) and switch on unit

2.  Remove suction hose from the material container, the re-

turn tube remains over the material container. 

3.  Immerse the suction system into a container filled with a 

suitable cleaning agent

4.  Turn the pressure control valve back in order to set a mini-

mal spraying pressure.

5.  Close relief valve,

 

valve position   

   (spraying)

6.  Pull the trigger guard of the spray gun in order to pump the 

remaining coating material from the suction hose, high-

pressure hose and the spray gun into an open container 

(if appropriate, increase the pressure at the pressure con-

trol valve slowly in order to obtain a higher material flow). 

When using multiple-gun operation the trigger guards 

must be pulled in succession, in order to increase the 

cleaning performance.

The container must be earthed in case of 

coating materials which contain solvents.

Caution! Do not pump or spray in container 

with small opening (bunghole)!

See safety regulations.

7.  Open relief valve

 

valve position   

   (circulation)

8.  Pump suitable cleaning agent in the circuit for several 

minutes.

9.  Close relief valve,

 

valve position   

   (spraying)

10.  Pump the remaining cleaning agent into an open contain-

er until the pump is empty. 

11.  Switch off the unit

Warm water improves the cleaning effect in 

the case of water-dilutable coating materials.

First unplug the power plug from the outlet.

Danger of short-circuits caused by water 

ingression! Never spray down the unit with 

high-pressure or high-pressure steam clean-

ers.

The suction hose is only solvent-resistant to 

a limited extent. Do not immerse in solvent, 

only wipe.

Wipe down unit externally with a cloth which has been im-

mersed in a suitable cleaning agent.

Clean filters always ensure maximum volume, 

constant spray pressure and problem-free 

functioning of the unit.

Unit with suction system

1.  Unscrew the filter (Item 1) 

from the suction tube (2).

2.  Disassemble filter by ro-

tating the base (3).

3.  Clean or replace the filter.

 

Carry out cleaning with 

a hard brush and a corre-

sponding cleaning agent.

1.  Open relief valve

 

valve position   

   (circulation) - Switch the unit off.

2.  Open the high-pressure filter and clean the filter insert. To 

do so:

3.  Unscrew the filter housing (1) by hand.

4.  Remove the filter insert (2) and pull out the bearing spring 

(3).

5.  Clean all the parts with the corresponding cleaning agent. 

If compressed air is available – blow through the filter in-

sert and bearing spring.

6.  When mounting the filter ensure that the bearing ring (4) 

in the filter insert is positioned correctly and check the O-

ring at the filter housing for damage.

7.  Screw on the filter housing by hand until it stops (a higher 

tightening force only impedes later dismantling).

1

3

2