Wagner SprayTech 7000 Manual De Usuario

1

3

2

c lean Ing  the  un It  / s erv Ic Ing

1.  Rinse the Airless spray gun with a suitable cleaning agent 

under lower operating pressure.

2.  Clean the tip thoroughly with a suitable cleaning agent 

so that no suitable coating material rests remain. 

3.  Clean the outside of the Airless spray gun thoroughly.

1.  Pull the protective bracket (1) forwards.

2.  Screw the grip (2) out of the gun housing. Pull out the in-

sertion filter (3).

3.  If the insertion filter is clogged or defective, replace it.

1.  Slide the insertion filter (3) with the longer cone into the 

gun housing.

2.  Screw the grip (2) into the gun housing and tighten it.

3.  Latch in the protective bracket (1).

An annual expert check is highly recom-

mended to be sure to have a safe unit.

You can servicing of the unit carried out by 

the Wagner Service. Favourable conditions 

can be agreed with a service agreement and/

or maintenance packages.

1.  Check the high-pressure hose, spray gun with rotary joint, 

power supply cable with plug for damage.

2.  Check whether the pressure gauge can be read.

1.  Check inlet-, outlet-, relief valve according wear. Clean it 

and replace worn out parts.

2.  Check all filter inserts (spray gun, suction system) clean it 

and replace if necessary.

Inspect the high-pressure hose visually for any notches or 

bulges, in particular at the transition in the fittings. It must be 

possible to turn the union nuts freely. A conductivity of less 

than 1 MΩ must exist across the entire length.

Have all the electric tests carried by the Wag-

ner Service.

Switch the unit off.

Before all repair work: Unplug the power 

plug from the outlet.

1.  Use a 17 mm spanner to screw out the inlet valve button.

2.  Replace the wiper (1) and O-ring (2).