Maytag W10359302A Hoja De Datos

1. Unplug refrigerator or disconnect power.

2. Attach the copper tube to the valve inlet using a compression 

nut and sleeve as shown. Tighten the compression nut. Do 
not overtighten.

3. Use the tube clamp on the back of the refrigerator to secure 

the tubing to the refrigerator as shown. This will help avoid 
damage to the tubing when the refrigerator is pushed back 
against the wall.

4. Turn shutoff valve ON. 

5. Check for leaks. Tighten any connections (including 

connections at the valve) or nuts that leak. 

6. The ice maker is equipped with a built-in water strainer. If 

your water conditions require a second water strainer, install 
it in the 

¹⁄₄" (6.35 mm) water line at either tube connection. 

Obtain a water strainer from your nearest appliance dealer.

1. Plug into a grounded 3 prong outlet.

NOTE: Allow 24 hours to produce the first batch of ice. Discard 
the first three batches of ice produced. Allow 3 days to 
completely fill ice container.

Depending on the width of your doorway, you may need to 
remove the doors to move the refrigerator into your home. Also, 
the door hinges are factory installed on the right-hand side. If you 
want the door to open from the other direction, you must reverse 
the door swing.

■

Before you begin, turn the refrigerator control OFF, unplug 
refrigerator or disconnect power. Remove food and any 
adjustable door or utility bins from doors. 

■

Depending on your model, your refrigerator has either 
Style1-Contour Doors or Style 2 - Standard Doors. 
Reference the graphic specific to your model later in this 
section following “Final Steps.” 

NOTE: For contour door models only - A Reversibility kit, 
which includes a new Brand Badge and hole covers, is 
available. To purchase a reversibility kit, see “Accessories” for 
contact information, and order Part Number W10395149. 

Tools Needed: 

⁵⁄₁₆" hex head socket wrench, #2 Phillips 

screwdriver, flat-blade screwdriver, 

⁵⁄₁₆" open-end wrench, flat 2" 

putty knife.

⁵⁄₁₆

1. Unplug refrigerator or disconnect power.

2. Using a hex head socket wrench, remove the three 

⁵⁄₁₆" hex 

head hinge screws from the top hinge and lift up to remove 
the hinge.

NOTE: Provide additional support for the doors while the 
hinges are being moved. Do not depend on the door magnets 
to hold the doors in place while you are working. 

3. Lift the freezer door off of the center hinge and set it aside.

4. Remove the washer from the top of the Center Hinge pin.  

A

C

B

D
E

⁵⁄₁₆

A

B

C

D

A