3com 7000 Manual Suplementario
Configuring VP Tunnels
221
■
Commands to define a VP tunnel at an enabled port
■
■
■
For more information about VP tunnels, see “VP Tunneling” on page 5-101.
Display VP Tunneling
Mode
Displays the VP tunneling mode of the CoreBuilder 7000 family ATM
switch. The mode can be enabled or disabled. VP tunnels can be
configured only if VP tunneling mode is enabled. For more information,
see “VP Tunneling” on page 5-101.
switch. The mode can be enabled or disabled. VP tunnels can be
configured only if VP tunneling mode is enabled. For more information,
see “VP Tunneling” on page 5-101.
Command Actions
Command Result
Example
Enter:
1 1 9 1 1
The following message is displayed:
VP TUNNELING mode is Disabled
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(9) VPT: VP Tunneling Setup
(1) MOD: VP Tunneling Mode Setup
(1) GMD: VP Tunneling Get Mode
Direct access sequence:
1 1 9 1 1
System action taken:
The VP tunneling mode of the CoreBuilder 7000 family
ATM switch is displayed.
ATM switch is displayed.
System message display:
VP TUNNELING mode is Enabled/Disabled