Cisco Cisco Aironet 1552WU Outdoor Access Point Guía De Instalación
29
Layer 3 Network Operation
The access points support Layer 3 network operation. Access points and controllers in Layer 3
configurations use IP addresses and UDP packets, which can be routed through large networks.
Layer 3 operation is scalable and is the recommended operation.
configurations use IP addresses and UDP packets, which can be routed through large networks.
Layer 3 operation is scalable and is the recommended operation.
illustrates a typical Layer-3
wireless network configuration containing access points and a controller.
Figure 17
Typical Layer 3 Access Point Network Configuration Example
14
8
45
8
7
Preparing the Access Point
The access point is a radio device which is susceptible to common causes of interference that can
reduce throughput and range. Follow these basic guidelines to ensure the best possible performance:
reduce throughput and range. Follow these basic guidelines to ensure the best possible performance:
•
For information on planning and initially configuring your Cisco mesh network, refer to the Cisco
Wireless Mesh Access Points, Design and Deployment Guide, Release 7.0. These documents are
available on cisco.com.
Wireless Mesh Access Points, Design and Deployment Guide, Release 7.0. These documents are
available on cisco.com.
•
Do not install the access point in an area where structures, trees, or hills obstruct radio signals to
and from the access point.
and from the access point.
•
You can install the access point at any height, but best throughput is achieved when the access
points are mounted at the same height.
points are mounted at the same height.
Note
To perform path loss calculation and to determine how far apart to install access points,
consult an RF planning expert.
consult an RF planning expert.