Cisco Cisco Aironet 1310 Access Point Bridge Guía De Instalación
16
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
78-17634-01
Mounting the Access Point
Mounting the Access Point
To mount the access point on a rooftop or wall, follow these steps:
Step 1
Choose a mounting location for the access point. If you are using the integrated antenna, the mounting
location must provide a clear signal path to the remote access point. For more information, see
location must provide a clear signal path to the remote access point. For more information, see
.
Step 2
Find a solid mounting position for the base bracket, such as a stud or main building member on a roof
or external wall. It may be necessary to utilize a stud finder to find wooden structural members.
or external wall. It may be necessary to utilize a stud finder to find wooden structural members.
Step 3
Assemble the rooftop mount. For more information, see the
.
Step 4
Mount the rooftop bracket at the mounting location using the following user-provided hardware:
•
Wooden structure—four 1/4 x 2 inch (minimum) lag bolts
•
Concrete structure—four 1/4 x 1 inch (minimum) bolts with concrete anchors
shows the rooftop mast assembly:
Figure 4
Roof-Mount Mast
Make sure that the mounting pole is vertical. You can rotate the foot of the bracket to adjust the vertical
position for wall or sloped-roof mounting locations.
position for wall or sloped-roof mounting locations.
Step 5
Tighten the bolts to secure the mounting pole to the mounting foot. Torque nuts to 12 to 14 ft-lb.
Step 6
Attach the access point to the vertical section of the pole using the supplied brackets and hardware. For
more information, see the
more information, see the
88750