Cisco Cisco WAP571E Wireless-AC N Premium Dual Radio Outdoor Access Point Guía De Instalación

Smart PoE is designed for detecting the power level from the PSE (Power 
Sourcing Equipment) side; it does not matter whether 802.3at or 802.3af 
mode, the WAP571 will operate at the appropriate mode automatically. 

Smart PoE ensures that the WAP571E remains functional once powered by 
802.3af PSE, and intelligently to adjust operations below:

• Second Ethernet port disabled

• 2.4-GHz 802.11n radio in 2x2:2 spatial-stream mode

• 5-GHz 802.11ac radio operates without restrictions

In case of an error while installing, try the following troubleshooting 
procedures described in this section:

If you cannot display the configuration utility, you can test the ability of the 
computer to communicate with the device by using ping. 

To use ping on a computer running Windows:

Verify that the Cisco WAP571E is powered on and the lights 
indicate the appropriate links.

Locate the device’s IP address. While there are different ways to 
locate your device’s IP address, this procedure uses Cisco FindIT.

a.

If you have previously downloaded Cisco FindIT, open Internet 

Explorer and launch Cisco FindIT. For more information on 
downloading Cisco FindIT, see 

www.cisco.com/go/findit

.

b. In the Cisco FindIT display, place your mouse over the device’s 

name. The device IP address is displayed along with other 
device information.

Open a command window by choosing Start > Run and enter 
cmd.

At the command window prompt, enter ping and the device IP 
address. In this example, we pinged 192.0.2.10. 

If successful, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128