Cisco Cisco WAP571E Wireless-AC N Premium Dual Radio Outdoor Access Point Guía De Instalación

If it fails, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:
Request timed out.

• Power up the switch and your computer if they are turned off.

• Make sure your PoE switch is powered on and the lights indicate that 

you have a link. See 

• Verify that the devices on your network are not plugged into a 

switchable outlet.

• Check the state of the indicator lights. See 

.

• Check the Ethernet cable to ensure that it is firmly connected to your 

devices. Devices connected by the Ethernet cable can include the WAP 
device, and routers, any switches, and your computer.

• Verify the connected switch has auto-negotiation enabled. The access 

point and the switch need the same negotiation parameters set.

After a new firmware installation, if the Power light is solid red, contact 
system support; see 

.

The most likely cause of connectivity failure is an incorrect IP address. The 
Web browser may be pointing to the wrong IP address, or your computer 
may be configured with an IP address that is not in the same subnet as the 
device.

Because the factory default IP address configuration is DHCP, make sure 
that your DHCP server is running and can be reached. You may need to 
disconnect and reconnect the devices for them to discover their new IP 
addresses from the DHCP server. You can then query the DHCP server for 
the new IP address. See 

 of 

 for more information on how to find the DHCP address.