HP proliant dl580 Manual De Usuario

Removal and replacement procedures  16 

  WARNING:  To reduce the risk of personal injury or equipment damage, be sure that the 

rack is adequately stabilized before extending a component from the rack. 

  WARNING:  To reduce the risk of personal injury, be careful when pressing the server 

rail-release latches and sliding the server into the rack. The sliding rails could pinch your 
fingers. 

After performing the installation or maintenance procedure, slide the server back into the rack by 
pressing the server rail-release latches. 

  NOTE:  The release latches will lock into place when the rails are fully extended. 

 

 

Power down the server 

  WARNING:  To reduce the risk of personal injury, electric shock, or damage to the 

equipment, remove the power cord to remove power from the server. The front panel 
Power On/Standby button does not completely shut off system power. Portions of the 
power supply and some internal circuitry remain active until AC power is removed. 

  IMPORTANT:  If installing a hot-plug device, it is not necessary to power down the server. 

Shut down the OS as directed by the OS documentation. 

Press the Power On/Standby button to place the server in standby mode. When the server enters 
standby power mode, the system power LED changes to amber.  

Disconnect the power cords. 

The system is now without power. 

 

Remove the server from the rack 

To remove the server from an HP, Compaq branded, telco, or third-party rack: 

Power down the server (on page 

Extend the server from the rack ("

Disconnect the cabling and remove the server from the rack. For more information, refer to the 
documentation that ships with the rack mounting option. 

Place the server on a sturdy, level surface.