Digidesign 2 Manual De Usuario
Getting Started with Digi 002
90
Channel Volume Fader
The volume of each input is controlled by its
corresponding channel fader.
corresponding channel fader.
Pan
The pan position of each input on the stereo
output bus is controlled by its corresponding ro-
tary encoder when Digi 002 is in Pan View.
output bus is controlled by its corresponding ro-
tary encoder when Digi 002 is in Pan View.
Solo and Mute
The solo and mute status of each channel are
controlled by the corresponding switches on
each channel strip. In Stand-alone mode, the
Solo switches behave in latched fashion, allow-
ing more than one channel to be soloed at the
same time.
controlled by the corresponding switches on
each channel strip. In Stand-alone mode, the
Solo switches behave in latched fashion, allow-
ing more than one channel to be soloed at the
same time.
Channel Select Switch
Depending on the current view, the Channel Se-
lect switch performs a variety of functions. In
Pan/Send View, this switch toggles the corre-
sponding send between pre- and post-fader op-
eration. In Channel View, you press this switch
to select a channel and display the controls for
any of the internal effects on Digi 002.
lect switch performs a variety of functions. In
Pan/Send View, this switch toggles the corre-
sponding send between pre- and post-fader op-
eration. In Channel View, you press this switch
to select a channel and display the controls for
any of the internal effects on Digi 002.
Naming Channels
In Stand-alone mode, you can name the input
channels so that the name appears in each
channel’s scribble strip. (The names of the Mas-
ter Fader and Effect Return channels cannot be
changed.)
channels so that the name appears in each
channel’s scribble strip. (The names of the Mas-
ter Fader and Effect Return channels cannot be
changed.)
To change the name of an input channel:
1
If Digi 002 is not in Home View, press the Pan
switch in the upper left-hand corner of the Con-
sole View area to return the unit to Home View.
sole View area to return the unit to Home View.
2
Press F2 (Naming). The Channel Selector
switches flash on channels 2–8 and a cursor ap-
pears beneath the first character in the Scribble
Strip of channel 1. The Channel Select switch
below channel 1 lights solid to indicate that its
name is being edited.
pears beneath the first character in the Scribble
Strip of channel 1. The Channel Select switch
below channel 1 lights solid to indicate that its
name is being edited.
3
Turn the Rotary Encoder for the first channel
to select the first character. (Available characters
include uppercase and lowercase letters, numer-
als, and symbols.)
include uppercase and lowercase letters, numer-
als, and symbols.)
4
Press the Left and Right Arrow keys in the
Navigation Section of Digi 002 to move the cur-
sor left and right in the Scribble Strip display.
sor left and right in the Scribble Strip display.
5
When you are finished naming the first chan-
nel, you can press the Channel Select switch or
move the Rotary Encoder for another channel to
edit its name.
move the Rotary Encoder for another channel to
edit its name.
6
When you are finished naming channels,
press the Escape switch or F2 again to return to
Home View.
Home View.
The new channel names are retained in Stand-
alone mode as long as Digi 002 remains pow-
ered on.
alone mode as long as Digi 002 remains pow-
ered on.
To save the channel names for recall at a
later time, you can store the names as part
of a Snapshot. See “Storing Snapshots” on
page 97.
later time, you can store the names as part
of a Snapshot. See “Storing Snapshots” on
page 97.