bobcat t190 Manual De Usuario
T190 Compact Track Loader
33
Operation & Maintenance Manual
Cold Temperature Starting
WARNING
Do not use ether with glow plug (preheat) systems.
Explosion can result which can cause injury, death,
or severe engine damage.
Explosion can result which can cause injury, death,
or severe engine damage.
W-2071-0903
If the temperature is below freezing, perform the following
to make starting the engine easier:
to make starting the engine easier:
•
Replace the engine oil with the correct type and
viscosity for the anticipated starting temperature.
(See ENGINE LUBRICATION SYSTEM on Page 84.)
viscosity for the anticipated starting temperature.
(See ENGINE LUBRICATION SYSTEM on Page 84.)
•
Make sure the battery is fully charged.
•
Install an engine heater, available from your Bobcat
Loader dealer.
Loader dealer.
NOTE: The LCD of the Keyless Panel may not be
immediately visible when the temperature is
below -26°C (-15°F). It may take 30 seconds to
several minutes for the Display Panel to warm
up. All systems remain monitored even when
the display is off.
below -26°C (-15°F). It may take 30 seconds to
several minutes for the Display Panel to warm
up. All systems remain monitored even when
the display is off.
Warming The Hydraulic / Hydrostatic System
IMPORTANT
When the temperature is below -30°C (-20°F),
hydrostatic oil must be warmed before starting. The
hydrostatic system will not get enough oil at low
temperatures and will be damaged. Park the machine
in an area where the temperature will be above -18°C
(0°F) if possible.
hydrostatic oil must be warmed before starting. The
hydrostatic system will not get enough oil at low
temperatures and will be damaged. Park the machine
in an area where the temperature will be above -18°C
(0°F) if possible.
I-2007-1285
Let the engine run for a minimum of 5 minutes to warm
the engine and hydrostatic transmission fluid before
operating the loader.
the engine and hydrostatic transmission fluid before
operating the loader.
Figure 66
If the Fluid Pressure Icon light (1) [Figure 66] (Key
Switch Panel) or (2) [Figure 66] (Keyless Panel) comes
ON when operating the loader (cold), more warm up time
is needed.
Switch Panel) or (2) [Figure 66] (Keyless Panel) comes
ON when operating the loader (cold), more warm up time
is needed.
B-15553B
1
B-15552B
2