C&E FS20 4-channel Surfa-mount Switching capacity (max.) 3680 VA 46135 Hoja De Datos

Los códigos de productos

46135

11. Handling

Take note of all the safety instructions in this user manual.

Due to its construction (protection class IP65) the product can be used outdoors, provided that
the remote switch’s casing is fully and correctly closed.

The product must be assembled and wired properly and professionally.

If the casing is removed, the product may only be used when the following requirements
are fulfilled:

• The control panel cover is correctly screwed on to the lower casing with the three

plastic screws.

• The product is used indoors in dry and clean conditions.

• In case the product is secured in an outdoor area and programming is to be carried

out using the remote switch’s internal buttons, the dry and clean ambient conditions
still apply (for example, no rain, etc.).

Caution! Life-threatening danger!

Only people who are appropriately trained are permitted to carry out work on voltage-carrying
parts. If you are not appropriately trained, please consult a qualified electrician who is
authorised to carry out such work.

Never use the product immediately after it has been brought from a cold room into a warm one.
The condensation that forms could damage the device!

Allow the device to reach room temperature before switching it on. This may take
several hours.

Make sure that the insulation of the entire product is neither damaged nor destroyed.

Normally the remote switch is installed only once and remains fixed at the installation location.
Depending on the installation location, check occasionally that the product is in perfect
condition.